Products
Advantages
Houses equipped with energy saving systems, built by integrating new technologies, allow to obtain a high energy class, consequently increasing the value of the property. Compact and quick to install solutions to contain space and installation times, modular and scalable to facilitate design aspects. The low costs, both purchase and installation, allow a quick amortization of the investment.
The saving of drinking water, the reduction of consumption and high efficiency, allow an optimization of the energy balance of the system, also with a view to sustainable construction.
Application
Energy saving and sustainable resource management
At each shower, 100 liters of water at 36 ° C are discharged into the sewer, with an unsustainable expenditure of energy and resources. The recovery of residual heat at the exhaust can halve the caloric consumption necessary for heating domestic water while the recovery and subsequent reuse of 100 liters of water contributes to a responsible use of resources as well as significantly reducing consumption.
Grey water recovery
It is the gray water recovery system for irrigation or domestic use, pre-assembled and ready to be connected in minimal time during installation on site. Thanks to the use of membranes with a high degree of efficiency, the filtration level is very high and allows to remove bacteria and viruses, moreover, the new generation filters maintain their high performance over time, lengthening the maintenance intervals.
In fact, only one chemical washing of the membrane can be provided every 12/18 months and the automatic backwash cycle to keep the membranes clean, sends the residues directly to the drain into the sewer.
The system, which can be sized according to the number of users, is fully automatic and can be controlled remotely.
Stages of purification
- Primary filter+oxidation+ultrafiltration
- Storage
- Multistage filter+Activated carbon
- UV disinfection
Ecoshower
Ecoshower is the innovative solution that recovers up to 40% of heat from gray water to transfer it, flowing against the current in a coil, integrating the feed water of both the cauldron and the mixer (A) or the mixer only (B). The water that feeds the kettle, instant water heater or mixer from the "cold" side typically reaches 10 ° C and is heated up to 50 ° C, generating a consumption of about 40Kcal / l. With the integration of ecoshower inside the system, the incoming water is preheated around 24 ° C, reducing energy needs by 35%.
Ask for more information
