Sustainability
Reduced operating costs
Energy classification

Products

Advantages

Homes equipped with energy-saving systems, built by integrating new technologies, achieve a high energy class and consequently increase the value of the property. Solutions that are compact and quick to install to limit space and installation time, modular and scalable to facilitate design aspects. The low purchase and installation costs allow a rapid amortisation of the investment.
The savings in water consumption and high efficiency allow for an optimisation of the system's energy balance, also with a view to sustainable building.

Applications

Energy saving and sustainable resource management

For every shower 100 litres of water at 36° C are discharged into the sewage system, which is an unsustainable waste of energy and resources. Recovering the waste heat at the drain can halve the heat consumption needed to heat domestic water, while recovering and subsequently reusing 100 litres of water contributes to a responsible use of resources as well as significantly reducing consumption.

Grey water recovery

This is the grey water recovery system for irrigation or domestic use, pre-assembled and ready to be connected in minimal time during installation on site. Thanks to the use of high-efficiency membranes, the filtration level is very high and allows for the removal of bacteria and viruses. In addition, the new generation filters maintain their high performance over time, lengthening maintenance intervals.
In fact, only one chemical washing of the membrane every 12 to 18 months and the automatic backwash cycle to keep the membranes clean sends the residues directly to the sewer.
The system, which can be sized according to the number of users, is fully automatic and can be controlled remotely.

Purification phases

  • Primary filter+oxidation+ultrafiltration
  • Storage
  • Multistage filter+Activated carbon
  • UV disinfection
Ecoshower

Ecoshower is the innovative solution that recovers up to 40% of heat from grey water and releases it, flowing countercurrently in a coil, by integrating the water supply of both the boiler and the mixer (A) or the mixer alone (B). The water feeding the boiler, instantaneous water heater or mixer on the 'cold' side typically reaches 10° C and is heated up to 50° C, generating a consumption of about 40Kcal/l. With the integration of ecoshower into the system, the incoming water is preheated to around 24° C, reducing energy demand by 35%.


Ask for more information

Subscribe to Newletter

Your evaluation
Products
Information
Functionality